Cable Blog

How to Make Network Cables

In the ever-evolving landscape of network technology, the ability to craft your own Cat5e, Cat6, or other types of Network cables is a valuable skill. This guide provides both a foundational understanding for newcomers and a quick reference for the seasoned professionals.

Background and Specifications

Since the 1990s, Unshielded Twisted Pair (UTP) cabling has overtaken coaxial cable for Ethernet networks due to its ease of installation and cost-effectiveness. With the advent of 100Base-Tx and Gigabit Ethernet (1000Base-T), the evolution from CAT3 and CAT4 to CAT5 and beyond has been necessary.

The following table outlines the industry standard specifications for modern twisted-pair network cables:

Category Type Frequency Max Length LAN Applications Attenuation (dB/100m MAX@100MHz) Characteristic Impedance (ohms) NEXT dB (MIN@100MHz)
CAT5 UTP 100 MHz 100m 100Base-Tx, CDDI, 52-155Mbps ATM 22 dB 100 ohms ±15% 32 dB
CAT5e UTP 100 MHz 100m 1000Base-T, 52-155Mbps ATM 22 dB 100 ohms ±15% 35 dB
CAT6 UTP 250 MHz 100m 1000Base-T, 155-622 Mbps ATM 19.8 dB 100 ohms ±15% 44 dB
CAT7 ScTP 600 MHz 100m 100 ohms ±15%

For a future-proof network, opt for UTP CAT6. However, CAT5 suffices for non-Gigabit Ethernet. Be mindful of cable types like CMR (riser) and CMP (plenum), with the latter being mandatory in certain installations.

Cable Anatomy

UTP cables are composed of 8 insulated wires, forming 4 twisted pairs, each pair color-coded for identification. There are two types of patch cables: straight through and crossover. Both utilize RJ45 connectors, but differ in wiring and application.

Color Codes and Pin Usage

Ethernet standards specify two color layouts: 568A and 568B. For straight through cables, both ends should match using one color code. For crossover cables, one end should use 568A and the other 568B, swapping the green and orange pairs.

Remember:

Termination Process

To create your cables:

  1. Use a quality crimper and have spare RJ45 plugs.
  2. Strip no more than 0.5 inch of the jacket, keeping wire insulation intact.
  3. Arrange wires in the correct order, untwisting only as necessary.
  4. Cut wires evenly and insert into the RJ45 connector.
  5. Double-check the order, ensure all wires reach the end, and crimp.

Additional Notes

Crossover cables connect similar devices, while straight through cables connect a device to a network hub or router. Modern network devices may feature auto-sensing ports that accommodate both cable types.

Cautions

Avoid running network cables near sources of Electromagnetic Interference (EMI). Adhere to bending radius guidelines and never exceed 25lbs of pulling pressure.

Conclusion

Whether you’re setting up a home network or managing an enterprise system, understanding how to make and choose the right network cables is crucial. By following the guidelines above, you can ensure a reliable and efficient network setup.

For more insights and articles on networking, visit 800908.com.

Exit mobile version